Frntend_Ctrlr Messages - Cisco 3110 Message Manual

Chapter 2 Message and Recovery Procedures

FRNTEND_CTRLR Messages

This section contains the front-end controller messages on stacking-capable switches.
Error Message FRNTEND_CTRLR-1-MGR_TXQ_FULL: The front end controller Tx queue
reached watermark level
Note
Error Message FRNTEND_CTRLR-2-SUB_INACTIVE: The front end controller [dec] is
inactive.
Note
OL-12191-01
This message applies only to the Catalyst Switch Module 3110.
There are too many messages in the queue between the front-end controller and the
Explanation
switch software.
Recommended Action Reset the switch. If the problem is not resolved, contact your Cisco technical
support representative because there might be a problem with the switch.
This message applies only to the Catalyst Switch Module 3110.
The front-end controller that controls the LEDs and the fan-control features is now
Explanation
inactive on the port controlled by the front-end controller. This does not affect the traffic on the port.
[dec] is the controller number.
Reset the switch. If the problem is not resolved, contact your Cisco technical
Recommended Action
support representative because there might be a problem with the switch.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
FRNTEND_CTRLR Messages
2-33