Igmp_Querier Messages - Cisco 3110 Message Manual

IGMP_QUERIER Messages

IGMP_QUERIER Messages
This section contains the IGMP querier messages.
Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out
General Query messages in VLAN [dec] because there is no IP address configured on
the system.
Error Message IGMP_QUERIER-4-PIM_ENABLED: The IGMP querier is operationally disabled
in VLAN [dec] because PIM has been enabled on the SVI.
Error Message IGMP_QUERIER-4-SNOOPING_DISABLED: The IGMP querier is operationally
disabled in VLAN [dec] because IGMP snooping has been disabled in this VLAN.
Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because PIM is no longer enabled on the SVI.
Error Message IGMP_QUERIER-6-SNOOPING_ENABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because IGMP snooping is no longer disabled.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-42
You must specify an IP address for the IGMP querier at either the global or per-VLAN
Explanation
level. [dec] is the VLAN ID.
Recommended Action Configure a source IP address for the IGMP querier.
PIM was detected on the SVI. Do not enable the IGMP querier when PIM is enabled on
Explanation
the SVI. [dec] is the VLAN ID.
Recommended Action Ensure that PIM is disabled on the SVI.
IGMP snooping is disabled on this VLAN. Do not enable the IGMP querier when IGMP
Explanation
snooping is disabled. [dec] is the VLAN IDs.
Recommended Action Confirm that IGMP snooping is enabled both globally and on the VLAN.
Explanation Protocol-Independent Multicast (PIM) is disabled on the switch virtual interface (SVI),
and the IGMP querier function is now enabled. [dec] is the VLAN ID.
No action is required.
Recommended Action
IGMP snooping was enabled. As a result, the IGMP querier function is now enabled.
Explanation
[dec] is the VLAN ID.
No action is required.
Recommended Action
Chapter 2 Message and Recovery Procedures
OL-12191-01