Gbic_Security Messages - Cisco 3110 Message Manual

GBIC_SECURITY Messages

GBIC_SECURITY Messages
This section contains the 10-Gigabit Ethernet module security messages.
The Catalyst Switch Module 3110X supports 10-Gigabit Ethernet modules and does not support Cisco
Note
Gigabit Interface Converter (GBIC) modules. Although the error message text refers to GBIC interfaces
and modules, the messages from the switch actually refer to the 10-Gigabit Ethernet module interfaces
and modules.
Error Message GBIC_SECURITY-4-EEPROM_CRC_ERR: EEPROM checksum error for GBIC in
[chars].
Note
Error Message GBIC_SECURITY-4-EEPROM_READ_ERR: Error in reading GBIC serial ID in
[chars].
Note
Error Message GBIC_SECURITY-4-EEPROM_SECURITY_ERR: GBIC in [chars] failed security
check.
Note
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-34
This message applies only to the Catalyst Switch Module 3110X.
Explanation The GBIC in the specified port has invalid EEPROM data. [chars] is the port in which
the GBIC is inserted.
Remove the GBIC from the port.
Recommended Action
This message applies only to the Catalyst Switch Module 3110X.
An error occurred while the switch was reading the GBIC type from the EEPROM.
Explanation
[chars] is the port in which the GBIC is inserted.
Remove the GBIC from the port.
Recommended Action
This message applies only to the Catalyst Switch Module 3110X.
Explanation The GBIC in the specified port has invalid EEPROM data. [chars] is the port in which
the GBIC is inserted.
Remove the GBIC from the port.
Recommended Action
Chapter 2 Message and Recovery Procedures
OL-12191-01