Cisco 3110 Message Manual page 39

Chapter 2 Message and Recovery Procedures
Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_VVLAN: Data VLAN [dec] on port [chars]
cannot be equivalent to the Voice VLAN
Explanation
the voice VLAN. [dec] is the VLAN, and [chars] is the port.
Recommended Action
the interface so that they are not equal. This causes the authentication to proceed normally on the
next retry.
Error Message DOT1X_SWITCH-5-ERR_VLAN_INTERNAL: Attempt to assign internal VLAN
[dec] to 802.1x port [chars]
Explanation
specified is used internally and cannot be assigned to this port. [dec] is the VLAN, and [chars] is the
port.
Recommended Action
Error Message DOT1X_SWITCH-5-ERR_VLAN_INVALID: Attempt to assign invalid VLAN [dec]
to 802.1x port [chars]
Explanation
specified is out of range and cannot be assigned to this port.[dec] is the VLAN, and [chars] is the
port.
Recommended Action
Error Message DOT1X_SWITCH-5-ERR_VLAN_NOT_FOUND: Attempt to assign non-existent or
shutdown VLAN [dec] to 802.1x port [chars]
Explanation
found in the VTP database. [dec] is the VLAN, and [chars] is the port.
Recommended Action
Error Message DOT1X_SWITCH-5-ERR_VLAN_ON_ROUTED_PORT: Dot1x cannot assign a VLAN
[dec] to a routed port [chars]
Explanation
allowed. [dec] is the VLAN ID, and [chars] is the port.
Recommended Action
port.
OL-12191-01
An attempt was made to assign a data VLAN to an IEEE 802.1x port that is the same as
Change either the voice VLAN or the access/IEEE 802.1x-assigned VLAN on
An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
Update the configuration to not use this VLAN.
An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN
Update the configuration to use a valid VLAN.
An attempt was made to assign a VLAN to an IEEE 802.1x port, but the VLAN was not
Make sure that the VLAN exists and is not shut down, or use another VLAN.
An attempt was made to assign a VLAN to a supplicant on a routed port, which is not
Either disable the VLAN assignment, or change the port type to a nonrouted
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
DOT1X_SWITCH Messages
2-23