Cisco 3110 Message Manual page 82

PM Messages
Error Message PM-4-BAD_VLAN_ID: an invalid vlan id ([dec]) was detected.
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
Error Message PM-4-ERR_DISABLE: [chars] error detected on [chars], putting [chars]
in err-disable state.
Explanation
in an error-disabled state. A recovery is attempted after the configured retry time (the default is 5
minutes). [chars] is the port where the threshold was exceeded. The first [chars] is the error, and the
second and third [chars] are the affected interfaces.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
Error Message PM-4-ERR_DISABLE_VP: [chars] error detected on [chars], vlan [dec].
Putting in err-disable state.
Explanation
error-disabled state when it detects a misconfiguration or misbehavior. If configured, a recovery will
be attempted after the configured retry time (default time is 5 minutes). The first [chars] is the error,
and the second [chars] is the port.
Recommended Action
Research and attempt to resolve the error using the Output Interpreter. Use the Bug Toolkit to look
for similar reported problems. If you still require assistance, open a case with the TA C, or contact
your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-66
The port manager detected an invalid request. [dec] is the VLAN ID.
Copy the message exactly as it appears on the console or in the system log.
1-6.
The port manager detected a misconfiguration or misbehavior and placed the interface
Copy the message exactly as it appears on the console or in the system log.
1-6.
This is a defensive measure that puts the virtual port (that is, the port-VLAN pair) in an
Copy the message exactly as it appears on the console or in the system log.
Chapter 2 Message and Recovery Procedures
"Error Message Traceback
"Error Message Traceback
1-6.
"Error
OL-12191-01