Platform_Ucast Messages; Platform_Span Messages - Cisco 3110 Message Manual

Catalyst switch module for ibm bladecenter system
Hide thumbs Also See for 3110:
Table of Contents

Advertisement

PLATFORM_SPAN Messages

Error Message PLATFORM_RPC-3-UNABLE_TO_SEND: System is unable to send RPC message:
[chars], paks_outstanding: [int].
Note
PLATFORM_SPAN Messages
This section contains the Switched Port Analyzer (SPAN) messages.
Error Message PLATFORM_SPAN-3-PACKET_DROP: Decreases egress SPAN rate.

PLATFORM_UCAST Messages

This section contains platform unicast routing messages.
Error Message PLATFORM_UCAST-3-ADJ: [chars].
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-58
This message applies only to the Catalyst Switch Module 3110.
The system had a low-level transport failure when trying to send an RPC message.
Explanation
[chars] is a description of the error returned by the low-level packet sending driver that triggered the
error (usually one of these: fifo full, fifo empty, out of buf, out of mem, null pointer, misc failure),
and [int] is the number of packets outstanding (packets from the RPC code to the driver that have
not yet been sent).
Find out more about the error by using the show tech-support privileged EXEC
Recommended Action
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
Reports" section on page
Egress SPAN rates are falling because SPAN is enabled with multicast routing or
Explanation
fallback bridging.
Find out more about the error by using the show tech-support privileged EXEC
Recommended Action
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
Reports" section on page
The adjacency module for unicast routing encountered an error. [chars] describes the
Explanation
error.
Recommended Action
Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
1-6.
1-6.
"Error Message Traceback Reports" section on page
Chapter 2
Message and Recovery Procedures
"Error Message Traceback
"Error Message Traceback
1-6.
OL-12191-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

3112

Table of Contents