Cisco 3110 Message Manual page 36

DOT1X Messages
Error Message DOT1X-5-ERR_PVLAN_EQ_VVLAN: Dot1x can not be enabled on a port with
Access VLAN equal to Voice VLAN.
Explanation
access VLAN and the voice VLAN. This occurred because the switch tried to set IEEE 802.1x port
control to auto or force-unauthorized mode on the port, which is not allowed.
Recommended Action
802.1x operation.
Error Message DOT1X-5-ERR_RSPAN_VLAN: Dot1x can not be enabled on ports configured
in Remote SPAN vlan.
Explanation
port. This occurred because the switch tried to set IEEE 802.1x port-control to auto or
force-unauthorized mode on a port assigned to an RSPAN VLAN, which is not allowed.
Recommended Action
Error Message DOT1X-5-ERR_SPANDST: Dot1x can not be enabled on [chars].
configured as a SPAN Dest port.
Explanation
Recommended Action
802.1x authentication on the port.
Error Message DOT1X-5-ERR_TRUNK: Dot1x can not be enabled on Trunk port.
Explanation
because the switch tried to set IEEE 802.1x port control to auto or force-unauthorized mode on a
trunk port, which is not allowed.
Recommended Action
authentication on the port.
Error Message DOT1X-5-ERR_VLAN_INVALID: The VLAN [dec] is invalid and cannot be
assiged for use on the Dot1x port [chars] Vlan
Explanation
is the VLAN, and [chars] is the IEEE 802.1x port.
Recommended Action
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-20
IEEE 802.1x authentication could not be enabled on a port with the same VLAN for the
Change the voice VLAN or access VLAN on the interface, and retry the IEEE
IEEE 802.1x authorization could not be enabled on the remote SPAN (RSPAN) VLAN
Disable RSPAN on the VLAN, and retry the IEEE 802.1x operation.
IEEE 802.1x and SPAN destination ports are mutually exclusive. [chars] is the port.
Disable the SPAN destination port configuration, and then reconfigure IEEE
IEEE 802.1x authentication could not be enabled on the trunk port. This occurred
Disable trunking on the interface, and try to re-enable IEEE 802.1x
The specified VLAN is out of range and cannot be assiged as an IEEE 802.1x port. [dec]
Reconfigure the configuration to use a valid VLAN.
Chapter 2 Message and Recovery Procedures
It is
OL-12191-01