Cisco 3110 Message Manual page 106

STACKMGR Messages
Error Message STACKMGR-4-MASTER_ELECTED: Switch [dec] has been elected as MASTER of
the stack.
Note
Explanation
elected stack master.
Recommended Action
Error Message STACKMGR-4-STACK_LINK_CHANGE: Stack Port [chars] Switch [dec] has
changed to state [chars].
Note
Explanation
stack port (1 or 2), [dec] is the switch number, and the second [chars] is the new state (up or down).
Recommended Action
Error Message STACKMGR-4-SWITCH_ADDED: Switch [dec] has been ADDED to the stack.
Note
Explanation
number.
Recommended Action
Error Message STACKMGR-4-SWITCH_ADDED_SDM: Switch [dec] has been ADDED to the stack
(SDM_MISMATCH).
Note
Explanation
SDM_MISMATCH means that the added switch cannot support the SDM template that the stack
master is using. Subsequent SDM-6-MISMATCH_ADVISE messages explain the mismatch and
recommend corrective actions.
Recommended Action
SDM_MISMATCH corrective actions, see SDM-6-MISMATCH_ADVISE.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-90
This message applies only to the Catalyst Switch Module 3110.
The specified switch has been elected stack master. [dec] is the switch number of the
No action is required.
This message applies only to the Catalyst Switch Module 3110.
The specified stack port status has changed state to up or down. The first [chars] is the
No action is required.
This message applies only to the Catalyst Switch Module 3110.
The specified stack member switch has been added to the stack. [dec] is the switch
No action is required.
This message applies only to the Catalyst Switch Module 3110.
The specified switch has been added to the stack. [dec] is the switch number.
No action is required unless SDM_MISMATCH is displayed. For
Chapter 2 Message and Recovery Procedures
OL-12191-01