Cisco 3110 Message Manual page 26

CFGMGR Messages
Error Message CFGMGR-4-MEMBER_WRITING_STARTUP_CFG: only master can do that.
Note
Explanation
stack master can write to the startup configuration file.
Recommended Action
Error Message CFGMGR-5-UNABLE_TO_USE_PROVISIONED_CFG: Switch [dec] will receive the
default configuration.
Note
Explanation
for its switch number; therefore, the default configuration is applied to this switch. [dec] is the stack
member number.
Recommended Action
Error Message CFGMGR-6-APPLYING_RUNNING_CFG: as new master.
Note
Explanation
Recommended Action
Error Message CFGMGR-6-SPURIOUS_MEMBER_ADD: CFG MGR Recvd Spurious New Member
Notification: [int].
Note
Explanation
that already exists in the stack. [int] is the switch number.
Recommended Action
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, contact IBM technical
support and provide the representative with the gathered information. For more information about
the online tools and about contacting IBM, see the
page
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
2-10
This message applies only to the Catalyst Switch Module 3110.
A stack member switch attempted to write to the startup configuration file; only the
No action is required.
This message applies only to the Catalyst Switch Module 3110.
The switch type of the specified switch does not match the provisioned configuration
No action is required.
This message applies only to the Catalyst Switch Module 3110.
A new stack master is applying the backed-up running configuration.
No action is required.
This message applies only to the Catalyst Switch Module 3110.
The configuration manager received a notification about adding a stack member switch
If this message recurs, copy it exactly as it appears on the console or in the
1-6.
Chapter 2 Message and Recovery Procedures
"Error Message Traceback Reports" section on
OL-12191-01