Cisco 3110 Message Manual page 21

Catalyst switch module for ibm bladecenter system
Hide thumbs Also See for 3110:
Table of Contents

Advertisement

Chapter 2
Message and Recovery Procedures
Error Message ACLMGR-3-MAXRECURSION: Too many ([dec]) levels of recursion while
merging ACLs (code [dec]).
Explanation
support. The most likely cause is too many separate access lists in a single VLAN map or policy
map. The first [dec] is the number of levels of recursion. The second [dec] is an internal code number
of the merge stage that encountered the problem.
Recommended Action
one VLAN or policy map to fewer than the number of levels reported by this log message.
Error Message ACLMGR-3-MERGEFAIL: [chars] ACL merge error [dec] ([chars]) on [chars]
label [dec].
Explanation
form suitable for loading into the hardware. Packets potentially affected by this feature will be sent
to the CPU for processing instead. The most likely cause is specifying an ACL that is too large or
too complex for the system. The first [chars] is the ACL-type error (ip or mac), the first [dec] is the
error code, the second [chars] is the message string for the preceding error code, the second [dec] is
the label number, and the third [chars] is either input or output.
Recommended Action
Error Message ACLMGR-3-NOLABEL: Cannot allocate [chars] label for interface [chars].
Explanation
means that the hardware cannot be programmed to implement the features, and packets for this
interface will be filtered in software. There is a limit of 256 labels per direction. The first [chars] is
the direction (input or output); the second [chars] is the interface name.
Recommended Action
possible.
Error Message ACLMGR-3-OUTTTABLE: Not in truth table: RACL [dec] VLMAP [dec].
Explanation
and second [dec] are the internal action codes.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
Reports" section on page
OL-12191-01
The configuration is too complicated for the platform-specific ACL merge code to
Reduce the number of IP or MAC access lists (considered separately) in any
The ACL manager was unable to complete the merge of the configured features into a
Specify a smaller and less complicated configuration.
The ACL manager could not allocate a label for the features on this interface. This
Use a simpler configuration. Use the same ACLs on multiple interfaces, if
A software error occurred while trying to merge the configured output features. The first
Copy the message exactly as it appears on the console or in the system log.
1-6.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
ACLMGR Messages
"Error Message Traceback
2-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

3112

Table of Contents