Pimsn Messages - Cisco 3110 Message Manual

Chapter 2 Message and Recovery Procedures

PIMSN Messages

This section contains the PIMSN messages for the Protocol Independent Multicast (PIM) snooping
feature.
Error Message PIMSN-6-IGMPSN_GLOBAL: PIM Snooping global runtime mode [chars] due to
IGMP Snooping [chars].
Error Message PIMSN-6-IGMPSN_VLAN: PIM Snooping runtime mode on vlan [dec] [chars]
due to IGMP Snooping [chars].
PLATFORM Messages
This section contains low-level platform-specific messages.
Error Message PLATFORM-1-CRASHED: [chars].
Error Message PLATFORM-3-NO_HARDWARE_RESOURCES: Not enough hardware resources.
Shutting down [chars].
OL-12191-01
Explanation IGMP snooping must be enabled for PIM snooping to run. When IGMP snooping is
disabled, PIM snooping is disabled. When IGMP snooping is re-enabled, PIM snooping is
re-enabled. The first [chars] is the PIM snooping mode, and the second [chars] is the IGMP snooping
mode.
No action is required.
Recommended Action
IGMP snooping must be enabled for PIM snooping to run. When IGMP snooping is
Explanation
disabled, PIM snooping is disabled. When IGMP snooping is re-enabled, PIM snooping is
re-enabled. [dec] is the VLAN ID, the first [chars] is the PIM snooping mode, and the second [chars]
is the IGMP snooping mode.
No action is required.
Recommended Action
The system is attempting to display the failure message from the previous failure.
Explanation
[chars] is the description of the error message.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
There are too many VLANs and routed ports. [chars] is the short interface name, such
Explanation
as Gi1/0/1, or the VLAN name, such as VLAN0002.
Reduce the total number of VLANs and routed ports to be less than 1023. To
Recommended Action
preserve configurations and connections across reboots, save the configuration.
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
"Error Message Traceback Reports" section on page
PIMSN Messages
1-6.
2-47