Defining The Upper Limit For The Spindle Speed (In The Turning Application Mode); Upper Limit For Spindle Speed Dialog - HEIDENHAIN ND 7000 Operating Instructions Manual

Turning – Manual operation | Defining the upper limit for the spindle speed (in the Turning application mode)
12.2 Defining the upper limit for the spindle speed (in the
Turning application mode)
If the unit is configured with the Turning application mode and a spindle axis S,
then you must define an upper limit for the spindle speed prior to a possible
machining operation.
For this purpose, the Upper limit for spindle speed appears after every switch-on.
Figure 48: Upper limit for spindle speed dialog
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Tap the Maximum spindle speed input field
Enter the upper limit for the spindle speed with respect to
the currently used clamping equipment.
Confirm the entry with RET
Tap Confirm
The upper limit is now adopted by the unit
The Upper limit for spindle speed dialog is closed
12
191