Overview; Logging In For Commissioning - HEIDENHAIN ND 7000 Operating Instructions Manual

7
7.1

Overview

This chapter contains all the information necessary for commissioning the product.
During commissioning, the machine manufacturer's commissioning engineer
(OEM) configures the product for use on the specific machine tool.
The settings can be reset to the factory defaults.
Further information:
7.2

Logging in for commissioning

User login
To commission the unit, the OEM user must log in.
92
"Reset", Page 261
Make sure that you have read and understood the "Basic Operation"
chapter before carrying out the actions described below.
Further information: "Basic Operation", Page 57
The following steps must be performed only by qualified personnel.
Further information: "Personnel qualification", Page 27
Tap User login in the main menu
If required, log out the user who is currently logged in
Select the OEM user
Tap the Password input field
Enter the password "oem"
If the password does not match the default
password, ask a Setup user or OEM user for the
assigned password.
If the password is no longer known, contact a
HEIDENHAIN service agency.
Confirm entry with RET
Tap Log in
The user is logged in
The unit now opens the Manual operation operating mode
If the unit is configured with the Turning application mode and a
spindle axis S, then you must define an upper limit for the spindle
speed prior to a possible machining operation.
Further information: "Defining the upper limit for the spindle speed (in
the Turning application mode)", Page 191
If the reference mark search after unit start is active, then all of the
unit's functions will be disabled until the reference mark search has
been successfully completed.
Further information: "Reference marks (Encoder)", Page 252
Commissioning | Overview
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018