Inputs (Switching Functions); Outputs (Switching Functions) - HEIDENHAIN ND 7000 Operating Instructions Manual

16

Inputs (Switching functions)

16.6.4
Path:
Parameter
Control voltage on
Emergency stop active

Outputs (Switching functions)

16.6.5
Path:
Parameter
Coolant
Operational readiness
User-defined switching function
246
The switching functions are available only for units with ID number
1089179-xx.
The switching functions must not be used as a part of a safety function.
Settings ► Axes ► General settings ► Switching functions ► Inputs
The switching functions are available only for units with ID number
1089179-xx.
The switching functions must not be used as a part of a safety function.
Settings ► Axes ► General settings ► Switching functions ► Outputs
Explanation
Assignment of the digital input for querying the external control
voltage (e.g. for the machine to be controlled)
Default value: Not connected
Assignment of the digital input for querying whether an external-
ly connected emergency stop switch was activated
Default value: Not connected
Explanation
Assignment of the digital output for activating or deactivating the
coolant supply of the machine tool
Default value: Not connected
Assignment of the relay output set if an error (e.g. positioning
error or standstill error) occurs on an axis. The error results in
interruption of the axis control and power disconnection of the
configured analog outputs of the axis.
Default value: Not connected
Assignment of the relay output that activates for some seconds
after shutdown of the product. The relay is connected to a circuit
with self-retaining function that disconnects the product and
machine tool from power if this signal is applied.
The circuit can couple the switch-on/off of the product to the
switch-on/off of the machine tool to be controlled.
Default value: Not connected
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Settings | Axes