16.6.19 Adding Gear Stages - HEIDENHAIN ND 7000 Operating Instructions Manual

Settings | Axes
Parameters
Spindle ready
Spindle interrupt
Spindle protection device
Spindle sleeve final position +
Spindle sleeve final position –
Spindle position

16.6.19 Adding Gear stages

Settings ► Axes ► S► Gear stages ► +
Path:
Parameter
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Explanation
Assignment of a digital input; indicates that the spindle is in
reliable condition
Default value: Not connected
Assignment of a digital input; in active state it immediately
disconnects from power the configured analog output of the
spindle. A spindle movement is stopped without a ramp, axes
with automatic traverse are stopped if applicable and spindle
activation is prevented.
The machine tool builder is responsible for the
immediate stopping of the spindles.
Default value: Not connected
Assignment of a digital input; indicates whether an existing
spindle protection device is open or closed. This signal influ-
ences error messages and program run.
The machine tool builder is responsible for the
immediate shutdown of the spindles with opened
spindle protection.
Default value: Not connected
Assignment of a digital input for the upper limit switch of the
sleeves. The input is used for reversing the spindle with thread
cutting.
Default value: Not connected
Assignment of a digital input for the lower limit switch of the
sleeves. The input is used for reversing the spindle with thread
cutting.
Default value: Not connected
Assignment of a digital input; the signal positions the spindle at
low speed during stopping to a desired position
Default value: Not connected
Explanation
Adding a new gear stage with default name
Further information: "Configuring Gear stages", Page 258
16
257