Example Of A Block In The Mdi Mode - HEIDENHAIN ND 7000 Operating Instructions Manual

Turning – MDI mode | Executing blocks
Executing blocks
Figure 60: Example of a block in the MDI mode
1 Wizard
2 View bar
3 Distance-to-go display
4 MDI block
5 Status bar
6 Positioning aid
7 Spindle speed (machine tool)
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Tap Create on the status bar
A new block is displayed
or
The last programmed MDI block with all parameters is loaded
Select the desired block type in the Block type drop-down
list
Define the relevant parameters, depending on the block type
To load the current axis position, tap Actual position capture
in the appropriate input fields
Confirm each entry with RET
To run the block, tap END
The positioning aid is displayed
If the simulation window is active, the current block is
visualized
User intervention may be required, depending on the block;
the wizard will display the relevant instructions
Follow the instructions of the wizard
With multi-step blocks in wizards, tap Next to proceed to the
next step
1
2
7
4
3
6
5
14
213