Example Of A Block In The Mdi Mode - HEIDENHAIN ND 7000 Operating Instructions Manual

13
Executing blocks
7
Figure 53: Example of a block in the MDI mode
1 Wizard
2 View bar
3 Distance-to-go display
4 MDI block
5 Status bar
6 Spindle speed (machine tool)
7 Positioning aid
204
Tap Create on the status bar
A new block is displayed
or
The last programmed MDI block with all parameters is loaded
Select the desired block type in the Block type drop-down
list
Define the relevant parameters, depending on the block type
To load the current axis position, tap Actual position capture
in the appropriate input fields
Confirm each entry with RET
To run the block, tap END
The positioning aid is displayed
If the simulation window is active, the current block is
visualized
User intervention may be required, depending on the block;
the wizard will display the relevant instructions
Follow the instructions of the wizard
With multi-step blocks, such as machining patterns in
wizards, tap Next to proceed to the next step
1
2
6
Milling – MDI mode | Executing blocks
4
3
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
5