Logging In For Setup - HEIDENHAIN ND 7000 Operating Instructions Manual

Setup | Logging in for setup
8.2

Logging in for setup

User login
To set up the unit, the Setup user must log in.
If the unit is configured with the Turning application mode and a
spindle axis S, then you must define an upper limit for the spindle
speed prior to a possible machining operation.
Further information:
the Turning application mode)", Page 191
If the reference mark search after unit start is active, then all of the
unit's functions will be disabled until the reference mark search has
been successfully completed.
Further information:
If the reference mark search is active on the unit, then a wizard will ask you to
traverse the reference marks of the axes.
After logging in, follow the instructions of the wizard
The Reference symbol stops blinking upon successful completion of the
reference mark search
Further information:
Further information:
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Tap User login in the main menu
If required, log out the user who is currently logged in
Select the Setup user
Tap the Password input field
Enter the password "setup"
If the password does not match the default
password, ask a Setup user or OEM user for the
assigned password.
If the password is no longer known, contact a
HEIDENHAIN service agency.
Confirm entry with RET
Tap Log in
"Defining the upper limit for the spindle speed (in
"Reference marks (Encoder)", Page 252
"Operating elements of the position display", Page 78
"Activating the reference mark search", Page 95
8
121