Axes; Reference Marks - HEIDENHAIN ND 7000 Operating Instructions Manual

16

Axes

16.6
This chapter describes settings for configuring the axes and assigned devices.

Reference marks

16.6.1
Path:
Parameters
Reference mark search after
unit start
All users can cancel reference
mark search
Reference mark search
Reference mark search status
Stop of reference mark search
244
Settings ► Axes ► General settings ► Reference marks
Explanation
Setting for the reference mark search after unit start
Settings:
ON: The reference mark search must be performed after
startup
OFF: No prompt for a mandatory reference mark search is
displayed after startup of the product
Default value: ON
Specifies whether the reference mark search can be canceled by
all user types
Settings
ON: The reference mark search can be canceled by any user
type
OFF: The reference mark search can only be canceled by OEM
or Setup-user types
Default value: OFF
Start starts the reference mark search and opens the workspace
Indicates whether the reference mark search was successful
Display:
Successful
Unsuccessful
Indicates whether the reference mark search was canceled
Display:
Yes
No
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Settings | Axes