Presetting A Position As Datum - HEIDENHAIN ND 7000 Operating Instructions Manual

Turning – Manual operation | Presetting a position as datum
12.4

Presetting a position as datum

When manually machining a workpiece on a machine tool, traverse the axes using
the handwheels. For simple machining operations, you can use the current position
as a datum and perform simple position calculations.
A workpiece is clamped on the machine tool
The reference mark search was successfully completed
Setting the current position as zero point
X
Defining the position values of the current position
X
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Move the tool manually to the desired position
Hold down Axis key
The active preset in the preset table is overwritten with the
current position
The active preset is applied as the new value
Perform the desired machining operation
Move the tool manually to the desired position
In the working space, tap Axis key or the position value
Enter the desired position value
Confirm the entry with RET
The position value is applied to the current position
The entered position value is linked with the current position
and overwrites the active preset in the preset table
The active preset is applied as the new value
Perform the desired machining operation
12
193