Example - Mdi Block; Example - Execution Of An Mdi Block With Scaling Factor - HEIDENHAIN ND 7000 Operating Instructions Manual

13
Example:
The following MDI block is programmed:
Figure 56: Example – MDI block
A Scaling factor of -0.5 is activated for the X axis. The following MDI block will
therefore be executed:
Figure 57: Example – Execution of an MDI block with scaling factor
208
If the calculated dimensions cannot be attained with the selected tool,
then the execution of the MDI block is aborted.
The scaling factor cannot be changed during execution of an MDI block.
Milling – MDI mode | Executing an MDI block with Scaling factor
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018