Steps For Commissioning; Selecting The Application; Basic Settings - HEIDENHAIN ND 7000 Operating Instructions Manual

7
7.3

Steps for commissioning

Loss of or damage to configuration data!
If the product is disconnected from the power source while it is on, the
configuration data can be lost or corrupted.
Back up the configuration data and keep the backup for recovery purposes

Selecting the Application

7.3.1
During commissioning of the unit, you can choose between the Milling and
Turning application modes. In its factory default setting, the unit is already set to
the Milling application mode.
7.3.2

Basic settings

Setting the date and time
Further information:
94
When you change the unit's application mode, then all of the axis
settings will be reset.
Tap Settings in the main menu
Tap Service
Open in the sequence
OEM area
Settings
Select the desired application mode in the Application drop-
down list:
Milling: Milling application mode
Turning: Turning application mode
Tap Settings in the main menu
Tap General
Tap Date and time
The set values are displayed in the following format: Year,
month, day, hour, minute
To set the date and time in the middle line, drag the columns
up or down
Tap Set to confirm
Select the desired format in the Date format list:
MM-DD-YYYY: Display as month, day, year
DD-MM-YYYY: Display as day, month, year
YYYY-MM-DD: Display as year, month, day
"Date and time", Page 233
Commissioning | Steps for commissioning
NOTICE
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018