Overview - HEIDENHAIN ND 7000 Operating Instructions Manual

9
9.1

Overview

This chapter describes the production of an example workpiece. While you
produce the example workpiece, this chapter leads step by step through the
product's various operating modes with use of various machining options. You
need to carry out the following machining steps for successful production of the
flange:
Machining step
Determine preset 0
Process a through hole
Process a rectangular pocket
Process a fit
Determine preset 1
Process a bolt hole circle
Process a row of holes
Figure 29: Example workpiece
This chapter does not describe processing of the outside contour of the example
workpiece. It is presumed that the outside contour is already machined.
152
Make sure that you have read and understood the "Basic Operation"
chapter before carrying out the actions described below.
Further information: "Basic Operation", Page 57
Mode of operation
Manual operation
Manual operation
MDI mode
MDI mode
Manual operation
MDI mode
MDI mode
HEIDENHAIN | ND 7000 | Operating Instructions | 05/2018
Milling – Quick Start | Overview