Endress+Hauser Mycom S CPM 153 Operating Instructions Manual page 126

11 Appendix
DIAG
List of current
Select
error messages
Error list
List of errors
entered in
Error log
error log
Operation log
List and status of
last 20
Calibration log calibrations
Service
126
List of last
20 operations
Select Set to default
values:
Factory settings Cancel
only setting data
only calibration data
all data; .....
Simulation
Simulation status off
Simulation
Curr.output 1 22.00 mA
Curr.output 2 00.00mA
Select test
functions
Display
Instrument check
RAM
EEPROM
Flash
Select DAT
DAT download
DAT write
DAT read
Log/Data log to DAT
Note!
After selection of
"Reset" a
Set up 2
warm start directly
will be made.
(Internal data
CPC
Chemoclean Test
Factory function
see below)
With service data: Info field if incorrect
service code
Enter entered:
service code
(necessary) --> return to Enter
Simulation Simulation
Sim.status off Sim.status off
Meas.value K1 07.00pH Failure contact off
Temperature T1 25.0°C Contact 1 off
Meas.value K2 00.00pH up to contact 5 off
Temperature T2 00.0°C
Test result:
Back to
RAM / EEPROM /
return field
Flash OK
Info field Info field before
saving into DAT:
No DAT module
connected! The data on the DAT
module will be
overwritten!
Mycom S CPM 153
Back to
return field
Back to
return field
»Return field«:
press the PARAM
= Code entry required
key to return to
the highlighted
fields.
Endress+Hauser