A102 Dc-Dc Converter - Agilent Technologies 35670A Service Manual

HSYNCELn
VCLK
VID
VSYNCEL
Agilent 35670A

A102 DC-DC Converter

The following table lists signals routed between the A7 CPU assembly and the
A102 DC-DC Converter assembly. This table shows several things — if the assembly
generates or uses the signal or voltage, and if a signal is bidirectional. A description of
each signal follows the table.
Signal Name
HSYNCELn
VCLK
VID
VSYNCEL
+12 V
+5 V
Gnd
Not Used
S This assembly is the source of the signal.
• This assembly uses the signal.
— This assembly does not use this signal.
Horizontal Synchronization — A low on this line causes a horizontal retrace on the
A101 Display assembly. Between each HSYNCELn pulse, 560 pixels are sent to the Display
assembly.
Video Clock — This 20 MHz clock provides the timing reference for HSYNCELn, VID, and
VSYNCEL. The rising edge of this clock determines setup and hold times.
Video Data — This is the serial data line for the A101 Display assembly. This line transmits
video data to the Display assembly. The video data is transmitted at the VCLK rate between
horizontal and vertical retraces (during the time HSYNCELn is high and VSYNCEL is low).
Only the first 400 lines of data are displayed after a VSYNCEL pulse.
Vertical Synchronization — A high on this line causes a vertical retrace on the A101 Display
assembly.
Pin(s)
11
13
15
9
1, 2
3, 4
7, 8, 10, 12, 14, 16
5, 6
Voltages and Signals
A102 DC-DC Converter
A7 P2
S
S
S
S
•
•
•
—
A102
•
•
•
•
•
•
•
—
9-37