Agilent Technologies 35670A Service Manual page 67

Warning
Agilent 35670A
• Press the following keys and type in the printer address when the program
prompts you:
[ ]
TEST CONFIG
[
PRINTER ADDRESS
[ ]
PROCEDURE
[ ] or [
OP_VERIFY PERFORMAN
[ ]
STOP AFTER
[ ] or [
LIMIT FAILURE
[ ]
RETURN
• Press the following keys to start the test:
[ ]
START TESTING
[
START BEGINNING
When you select [
START BEGINNING
printed only after all tests are done. When you select [
[ ], the data is printed immediately after each measurement.
ONE TEST
• Follow the directions on the display.
During the test, the program prompts you to change the test equipment
connections. Always turn the ac calibrator output to OFF or STANDBY before
changing test equipment connections. The ac calibrator can produce output
voltages that could result in injury to personnel.
The directions on the display briefly tell you how to connect test equipment. For
detailed illustrations of equipment setup, see the setup illustrations starting on page
3-13.
If you want to pause the program and return the Agilent 35670A Dynamic Signal
Analyzer to front panel control, press [
[ ] [
BASIC DISPLAY SETUP
any instrument setup states, press [
ensure accurate measurement results.
]
]
]
NONE
]
], the data is written to a file on the disk and
BASIC
] [ ] [
LOWER RETURN
RESTART TEST
Verifying Specifications
To run the program in semiautomated mode
START MIDDLE
]. To continue the program, press
] [ ]. If you changed
CONTINUE
] instead of [
CONTINUE
] or
]to
3-9