Table of Contents
Advertisement
ASSEMBLY
ASSEMBLY
FIGURE 15: After applying grease, install the sealing ring (6)
of the shaft, the anti-extrusion ring (7) and the scraper ring (8)
inside the cylinder (3).
CAUTION
Thoroughly check that positioning of the anti-extrusion ring
(7) is correct.
7
8
7
8
FIGURE 16: After applying grease, install the sealing ring (6)
of the shaft, the anti-extrusion ring (7) and the scraper ring (8)
in the head (2).
CAUTION
Thoroughly check that positioning of the anti-extrusion (7)
ring is correct.
52
Dana Holding Corporation
7
8
6
7
6
8
6
6
FIGURE 17: Fit the seal (9) onto the outside of the head (2).
CAUTION
1 - In order to facilitate assembly, apply grease to the outer
surface of the piston.
2 - Do not roll the seal (9) up.
11
13
13
12
12
FIGURE 18: Prepare the piston (5) by fitting it with the guide
ring (10), the magnetic ring (11), the o-ring (12) and the seal
(13).
CAUTION
1 - In order to facilitate assembly, apply grease.
2 - If a centering sensor is not fitted, then the magnetic ring
(11) should be replaced by another guide ring (10).
ASM-0025E - 212 Axle Service Manual
9
9
11
10
10
5
5
Advertisement
Table of Contents
