Table of Contents
Advertisement
ASSEMBLY
I max=0,80 A
NERO
BLACK
CONNETTORE
CONNECTOR
2
1
3
4
MARRON E
BROWN
FIGURE 36: Sensor connection card, OPTIONAL version.
FIGURE 37: Center the piston by slowly moving it first in one
direction then in the other. Position it half way on the stroke,
which is determined by the switching on and off of the signal
lamp of the inspection device in the reversal stage.
C C C
FIGURE 38: Inspect distance "C" on one side of the piston
and write down the size for checking later adjustments.
NOTE:
If cylinders come without a sensor, the centering of the
piston must be carried out on the basis of the maximum
stroke.
56
Dana Holding Corporation
BATTERIA
BATTERY
BLU
--
BLUE
+
2 A
=
= =
=
= =
T2
T1 2
FIGURE 39: Without moving the piston, check front and rear
size at the edge of tools T2 (See drawing T2 p. 59).
Maximum difference: 0.6 - 0.7 mm
NOTE:
In order to check the rear size, rotate the bevel pinion and
check that tools T2 (See drawing T2 p. 59) are flat.
FIGURE 40: If necessary, adjust convergency without moving
the centering of the piston and adjust the length of the stee-
ring bars (5) or (14).
NOTE:
With a half turn of screw, the front size is reduced by
about 3 mm, whereas the rear one is increased by about
3 mm.
ASM-0025E - 212 Axle Service Manual
T2
T1 2
5 14
Advertisement
Table of Contents
