Table of Contents
Advertisement
ASSEMBLY
9
FIGURE 35: Apply Loctite 510 to the locking surface of the
body of the reduction gear (11).
Lubricate snap rings (6) and (15); fit cover (9) and set cover (if
necessary) by lightly tapping with a plastic hammer.
8
FIGURE 36: Block cover (9) with screws (7) and (8) and rela-
tive washers (10). Tighten using the criss-cross method.
Torque wrench setting: 82 - 91 N·m.
3
2
FIGURE 37: Fit the upper (1) and lower (2) flanges.
Apply Loctite 242 to the threaded portion of pinion (20) and
upper gear (12).
Fit o-rings (4) and nuts (3).
168
Dana Holding Corporation
12
9
10
7
20
1
4
1
T6A
T20A
(T6B)
( T20B )
2
3
FIGURE 38: Apply tool T6A (See drawing T6 p. 174) (or T6B)
to flanges (1) and (2) and tighten nuts (3) using a dynamome-
tric wrench.
Torque wrench setting: 280 - 310 N·m.
ASM-0025E - 212 Axle Service Manual
Advertisement
Table of Contents
