Table of Contents
Advertisement
12
FIGURE 7: Introduce tool T1 (See drawing T1 p. 140) in-
between the planetary gears (12).
11
FIGURE 8: Using two pin-drivers, engage tool T1 (See dra-
wing T1 p. 140) in between the planetary gears (12).
CAUTION
Carefully check that tool T1 (See drawing T1 p. 140) keeps
in an aligned position with the pins (11) when locked.
T3A
T16A
T3A
T16A
FIGURE 9: Place the differential unit (9) under a press, posi-
tion guide bushing T2 (See drawing T2 p. 140) and insert
press tool T3A (See drawing T3 p. 141). Press press tool T3A
(See drawing T3 p. 141) to end of stroke.
ASM-0025E - 212 Axle Service Manual
T1
T1 4
12
FIGURE 10: Remove press tool T3A (See drawing T3 p. 141)
and bushing T2 (See drawing T2 p. 140).
NOTE:
In this state, the pin (11) is contained within tool T1 (See
drawing T1 p. 140).
9
FIGURE 11: Remove tool T1 (See drawing T1 p. 140) and pla-
netary pin (11) with it.
T2
T1 5
FIGURE 12: Leaving the released planetary in its position,
lock again tool T1 (See drawing T1 p. 140).
Repeat pin extraction operation on the second planetary pin
(11).
Repeat the same operations on the remaining pins.
DISASSEMBLY
T2
T1 5
T1
T1 4
12
Dana Holding Corporation
T3A
T16A
9
12
135
Advertisement
Table of Contents
