JLG 3507 Supplemental Repair Manual page 123

1
FIGURE 50: Fit the electronic sensor (1) and screw it up to the
limit stop. Unscrew sensor by 3/4 turn and lock into position
with nut. Locking torque: maximum 30 N·m.
CAUTION
Do not exceed the specified torque setting.
FIGURE 51: To release the negative brake during an emer-
gency, (lack of pressure due to vehicle breakdown), loosen
nuts (22) and screw studs (21) in an alternate and gradual
manner until you notice some preloading;
continue by giving another 1.5 turns.
ASM-0025E - 212 Axle Service Manual
21 22
FIGURE 52: When the emergency is over, loosen the studs in
an alternate manner until a 17 mm projection is obtained; lock
into position with the nuts (22) tightened to 15 N·m.
ASSEMBLY
Dana Holding Corporation 121