JLG 3507 Supplemental Repair Manual page 109

8
FIGURE 17: Insert the screws (8) and hold them in position
with the snap ring (7).
NOTE:
Make sure that the ring is properly set in its seat.
4
FIGURE 18: If the lever (6) has been removed, install it and
hold it in position with the snap ring (5).
Fit the shoes assembly (4).
FIGURE 19: Make sure that the shoes (4) center the slot of the
fulcrum pin and rest on the surface of the lever (6).
ASM-0025E - 212 Axle Service Manual
7
FIGURE 20: Fit the drum (1).
Make sure that the friction surface of the drum carries no
trace of grease and is perfectly clean.
5
6
2
3
NOTE:
Dana Holding Corporation
ASSEMBLY
1
107