Table of Contents
Advertisement
10
FIGURE 15: Fit the pin screws (10) making sure that they are
all of the same color.
See Service Part List "Brake" section for bolt color detail.
Apply Loctite 270 to the thread.
Torque wrench setting: 5 - 7 N·m.
FIGURE 16: Fit the reversal springs (8) on the piston (9).
CAUTION
Pay attention not to deform the connections of the springs.
FIGURE 17: Slightly lubricate the braking disks (7) and fit them
in the arm following the correct sequence; orient them so that the
oil circulation holes and the marks "B" are perfectly lined up.
ASM-0025E - 212 Axle Service Manual
8
9
8
B
B
7
NOTE:
When installing the steel discs, the slot corresponding to
the oil level cap should always be kept free.
FIGURE 18: Check that the positioning of the sealing ring (16)
on the arm is intact; install the complete arm.
Lock it into position using two screws (4) and washers (5).
FIGURE 19: Check the flatness of the arms using tool T2 (See
drawing T2 p. 24) and finally lock the arms with the screws (4)
and the washer (5) using the criss-cross method.
Torque wrench setting: 298 N·m
ASSEMBLY
16
T2
T2
Dana Holding Corporation
23
Advertisement
Table of Contents
