Table of Contents
Advertisement
ASSEMBLY
1
1
FIGURE 25: Fit the snap ring (1) on the head (2).
CAUTION
Make sure that the snap ring (1) is securely fastened in its
seat.
If necessary, force it into its seat using a drift and a hammer.
FIGURE 26: Check that the o-rings (15) of the axle unit are in
good condition; lubricate the seats of the seals (15) and fit the
steering cylinder (9) into its seat.
9
FIGURE 27: Lock the cylinder by criss-cross method the
screws (8).
Torque wrench setting: 116 - 128 N·m
54
Dana Holding Corporation
2
2
9
8
13
FIGURE 28: Apply Loctite 242 to the thread and connect the
steering bars by screwing the terminals onto the piston stem.
Torque wrench setting: 240 - 270 N·m
NOTE:
Versions with coupling require that the rim of the articu-
lation (13) is riveted onto the surfaces of the piston stem.
7
FIGURE 29: OLD VERSION
Insert the pins (4) in the steering case (7) and lock into posi-
tion using a torque wrench setting of 260 - 290 N·m.
Find the position of the notching in relation to the hole of the
cotter pins and tighten the nut (6) further.
CAUTION
Check that rubber guards (A) are intact.
ASM-0025E - 212 Axle Service Manual
A
A
Advertisement
Table of Contents
