Table of Contents
Advertisement
DISASSEMBLY
8
FIGURE 7: Remove the securing screws (8) from the steering
cylinder (9).
FIGURE 8: Extract the cylinder (9) using a plastic hammer.
NOTE:
For cylinder disassembly, refer to STEERING CYLINDER
p. 47.
1
FIGURE 9: Remove the snap ring (1) from the cylinder head
(2).
50
Dana Holding Corporation
9
9
2
FIGURE 10: With the help of a plastic hammer, push the head
(2) inside the cylinder (3).
NOTE:
The head should line up with the edge of the cylinder.
3
FIGURE 11: With the help of a drift, apply pressure to the
stop ring (4) that is placed inside the cylinder (3) and extract
the ring using a screwdriver.
2
FIGURE 12: Hammer the piston (5) on the rear of the head (2)
using a plastic hammer.
Continue hammering until the head (2) is ejected from the
cylinder (3).
ASM-0025E - 212 Axle Service Manual
3
2
4
5
3
Advertisement
Table of Contents
