JLG 3507 Supplemental Repair Manual page 43

FIGURE 25: Fit the bearing (15) into the internal thrust block.
FIGURE 26: Apply a repositionable jointing compound for se-
als to the outer surface of the sealing ring (14).
Position the sealing ring (14) in the hub (7).
NOTE:
Check that the ring (14) is correctly oriented.
FIGURE 27: Position tool T4 (See drawing T4 p. 46) and press
the sealing ring (14) into its seat.
ASM-0025E - 212 Axle Service Manual
15
14
7
T4
T1 0
14
FIGURE 28: Install the hub (7).
FIGURE 29: Install the external bearing (8).
NOTE:
Using a plastic hammer, drive the bearing to the limit stop
by lightly hammering around the edge.
FIGURE 30: Insert the flange (5) in the crown (13).
ASSEMBLY
7
8
5
13
Dana Holding Corporation 41