Table of Contents
Advertisement
FIGURE 19: Heat the ring nut (19) at approx. 80°C.
T2
T2 9
T1
T3 0
FIGURE 20: Engage special wrench T1 (See drawing T1
p. 169) on the ring nut (19) and apply bar-hold T2 (See dra-
wing T2 p. 170) on the pinion (20).
FIGURE 21: Remove ring nut (19).
ASM-0025E - 212 Axle Service Manual
19
19
20
FIGURE 22: Using a puller, extract pinion (20) complete with
inner bearing (21), spacer (22) and distance washers.
NOTE:
The thrust blocks of the bearings remain in the central
body (11).
20
FIGURE 23: Remove the complete pinion (20).
NOTE:
Carefully check and note direction of installation of spa-
cer.
FIGURE 24: Using a punch and a hammer, extract the snap
ring (25).
NOTE:
Note direction of installation of snap ring (24).
DISASSEMBLY
11
25
Dana Holding Corporation
165
Advertisement
Table of Contents
