Table of Contents
Advertisement
CAUTION
If the crown has been replaced, reinstate clearances.
For details, see DIFFERENTIAL UNIT p. 61.
FIGURE 30: Re-install the complete arm checking flatness
and blocking the arm by keeping to the appropriate procedu-
res illustrated in section CHECKING WEAR AND REPLACING
THE BRAKING DISCS p. 19.
Also connect the steering bar.
14
FIGURE 31: Using a press, fit the bearings (14) and the spa-
cer (16) on the upper gear (12).
CAUTION
The di stance piece (16) must be positioned between the
outer bearing and the gear.
ASM-0025E - 212 Axle Service Manual
FIGURE 32: Grease snap rings (15) and (6); position the snap
rings in the cover (9) using tool T5 (See drawing T5 p. 173).
FIGURE 33: Fit the lower gear (13) onto the pinion (20).
12
FIGURE 34: Insert the upper gear unit (12) into the body of
the reduction gear (11).
T5
T3 2
15
9
20
13
Dana Holding Corporation
ASSEMBLY
T5
T3 2
6
9
12
11
167
Advertisement
Table of Contents
