Table of Contents
Advertisement
ASSEMBLY
T5
T7C
T26C
T2 4
FIGURE 18: Insert tool T7B (See drawing T7 p. 81) complete
with external bearing (13), measurement ring T5 (See drawing
T5 p. 79) and gauged ring nut T7C (See drawing T7 p. 81).
Manually tighten.
T7A
T26A
GB
FIGURE 19: Fit a dial indicator "DG1" with long stem into bar
T7A (See drawing T7 p. 81); when the bar rests on two size-
blocks "GB" of 57 mm, reset the gauge.
Preset the gauge to approximately 2 mm and reset.
T7C
T26C
T7A
T26A
FIGURE 20: Lay bar T7A (See drawing T7 p. 81) on gauged
nut T7C (See drawing T7 p. 81) and take the measurement
"A" at about 57 mm corresponding to the maximum diameter
of arms centering.
72
Dana Holding Corporation
T7B
T26B
13
DG 1
GB
A A
T5
T24
T7B
T26B
30. 2
(61-A)+1 15+30.2=B
FIGURE 21: Calculate size "B" which will be the first useful
value for calculating the size of the shims (14) that are to be
inserted under the thrust block of the internal bearing (9).
8
FIGURE 22: Check the nominal size (X) marked on the pinion
and add or subtract the indicated variation (Y) so as to obtain
size "Z".
e.g.: Z= 118 + 0.1 = 118.1
Z= 118 ± 0.2 = 117.8
( )
S
C=Z+D
FIGURE 23: Calculate size "C" which represents the second
value for calculating the size of the shims "S" that are to be
placed under the thrust block of the internal bearing (9).
ASM-0025E - 212 Axle Service Manual
T7C
T26C
A
61
B
X
X
Y
Y
D
Z
C
Advertisement
Table of Contents
