JLG 3507 Supplemental Repair Manual page 161

FIGURE 38: Slightly lubricate the braking disks (14) and fit
them in the arm following the correct sequence; orient them
so that the oil circulation holes and the marks "B" are lined
up.
When installing the steel discs, the slot corresponding to the
oil level cap should always be kept free.
FIGURE 39: Check integrity and position of the arm's o-ring;
install the complete arm.
NOTE:
To assist axle shaft centering, slightly move the wheel
hub.
ASM-0025E - 212 Axle Service Manual
B
14
FIGURE 40: Torque wrench setting:
A = 200 N·m
B = 283 N·m
NOTE:
Tighten using the criss-cross method.
ASSEMBLY
A
B
Dana Holding Corporation 159