Table of Contents
Advertisement
FIGURE 16: Fit the spacer (2) and insert the pin of support
(10) in the right-hand braking lever. Fit the snap ring (1).
6
FIGURE 17: Rotate stem (6) to center the hole of the fulcrum
pin (3).
Apply Loctite 242 to the thread of the fulcrum pin (3), screw
and tighten pin with a torque wrench set to 25 - 30 N·m.
18
A
FIGURE 18: Check that a clearance "A" is left between the le-
ver (28) on the cylinder side (resting against the adjustment
stud) and cylinder (18).
If necessary, remove the lever, turn it by one tooth in relation
to the spline and repeat idle stroke elimination procedure.
ASM-0025E - 212 Axle Service Manual
10
2
1
FIGURE 19: Introduce pressure into the cylinder (4) and, with
the levers (28) resting against the adjustment studs (27),
screw rod (6) to engage the quick release (7) in the slot.
3
FIGURE 20: Lock nut (17) in position against the stem of the
piston (23).
Torque wrench setting for the nut: maximum 40 N·m.
27
28
FIGURE 21: Release the pressure and check that piston (23)
returns and stops in a position where it projects out from the
cylinder head (4) by 4 - 5 mm.
6
7
27
28
√ mm
18
23
Dana Holding Corporation
ASSEMBLY
4
23
17
4
23
101
Advertisement
Table of Contents
