Table of Contents
Advertisement
ASSEMBLY
12
FIGURE 31: Insert the snap ring (12) in order to fix the flange
(5) in the crown (13).
NOTE:
Carefully check that ring (12) is properly inserted in the
slot of the crown (13)
FIGURE 32: Fit the complete crown flange (5).
NOTE:
In order to fasten the flange (5), use a plastic hammer and
alternately hammer on several equidistant points.
42
Dana Holding Corporation
13
5
FIGURE 33: Apply Tecnolube Seal 101 grease to the surface
of the safety flange (6) which touches the crown flange (5).
Fit the safety flange (6).
5
FIGURE 34: Apply Loctite 242 to the studs and fit on the nuts
(4).
FIGURE 35: Tighten the nuts (4) using criss-cross method in
two stages.
Initial torque wrench setting: 120 N·m
Final torque wrench setting: 255 - 285 N·m
6
4
ASM-0025E - 212 Axle Service Manual
5
Advertisement
Table of Contents
