Table of Contents
Advertisement
10
11
FIGURE 25: Remove press tool T3B (See drawing T3 p. 141),
bushing T2 (See drawing T2 p. 140) and fit the snap ring (10)
onto the pin (11).
CAUTION
Make sure that the snap ring centers seat and positions it-
self on the differential unit face.
Repeat the operations on the other planetary pins.
9
FIGURE 26: Check that planetary have a light clearance in re-
lation to the first planetary gear.
Position the second differential side gear (6) and the second
friction disc assembly (7) into the differential unit (9).
ASM-0025E - 212 Axle Service Manual
FIGURE 27: Line the lubrication holes up with the slots in the
differential carrier. Orient the holes of the crown (4) towards
the protrusions of the braking unit. Position the crown (4) on
the differential unit (9) and lock it with the screws (3) previou-
sly coated with Loctite 242.
Torque wrench setting for screws: 128 - 142 N·m.
NOTE:
Tighten screws using the criss-cross method.
7
6
FIGURE 28: If bearings (5) and (8) have been removed, install
them using tool T4 (See drawing T4 p. 141).
FIGURE 29: Install the whole differential assembly (2) into the
central body (1).
For details, see DIFFERENTIAL UNIT p. 61.
9
T4
T1 7
5
1
Dana Holding Corporation
ASSEMBLY
3
4
T4
T1 7
8
2
139
Advertisement
Table of Contents
