Table of Contents
Advertisement
B-C=S
FIGURE 24: Calculate the difference between sizes "B" and
"C" so as to obtain the size "S" of the shim (14) that will go
under the thrust block of the internal bearing (9).
FIGURE 25: Insert shim "S" (14) and the thrust block of the
internal bearing (9) in the central body.
NOTE:
To hold shim "S" (14) in position, apply grease.
T6A
T6C
T25C
FIGURE 26: Position tool T6A (See drawing T6 p. 80) and ten-
sion rod T6C (See drawing T6 p. 80). Connect the tension rod to
the press, fasten the thrust block and then remove the tools.
NOTE:
Before going on to the next stage, make sure that the
thrust block has been completely inserted.
ASM-0025E - 212 Axle Service Manual
14
14
9
T25A
T7C
T26C
9
FIGURE 27: Position tools T7C (See drawing T7 p. 81) and
T7B (See drawing T7 p. 81) complete with tapered bearings
(9) and (13); manually tighten until a rolling torque has been
obtained.
DD G
FIGURE 28: Insert the stem of a depth gauge "DDG" in either
side hole of tool T7C (See drawing T7 p. 81); reset the gauge
with a presetting of approximately 3 mm.
T7C
T26C
9
FIGURE 29: Remove the depth gauge and release tools and
bearings from the central body.
Re-install all and insert the spacer (10) between bearings (9)
and (13); manually tighten the whole pack.
ASSEMBLY
13
T7B
T26B
10
13
T7B
T26B
Dana Holding Corporation
73
Advertisement
Table of Contents
