Table of Contents
Advertisement
6
FIGURE 6: Remove the sealing ring (6).
FIGURE 7: Position wrench T3 (See drawing T3 p. 78) onto
the ring nut (7) and apply bar hold T2 (See drawing T2 p. 78).
to the pinion (8). Stop wrench T3 (See drawing T3 p. 78) and
rotate the pinion so as to release and remove the ring nut (7).
NOTE:
If disassembly proves awkward, heat the ring nut to ap-
proximately 80°C.
T4
T2 3
FIGURE 8: Apply blocks T4 (See drawing T4 p. 79) and, with
the help of a puller, extract the pinion (8) complete with the in-
ternal bearing (9), the spacer (10) and shims (11).
NOTE:
The thrust blocks of the bearings remain in the central
body (12).
ASM-0025E - 212 Axle Service Manual
7
T2
T2 1
T3
T2 2
12
8
8
FIGURE 9: Remove the pinion (8), shims (11) and spacer (10).
FIGURE 10: Using a puller and a press, remove the inner be-
aring (9) from the pinion (8).
13
FIGURE 11: Remove the thrust block of the external bearing
(13).
DISASSEMBLY
10
11
8
9
Dana Holding Corporation
69
Advertisement
Table of Contents
