Table of Contents
Advertisement
ASSEMBLY
DD G
9
13
FIGURE 30: Insert depth gauge "DDG" into tool T7B (See
drawing T7 p. 81) T7C (See drawing T7 p. 81) and measure
variation "H" in relation to the zero setting performed back at
Figure 28.
H+ 0,12 √ 0,13 =S 1
FIGURE 31: The variation is to be added to a set value of 0.12
- 0.13 mm., so as to obtain the size of shim "S1" (11) which
will be inserted between the external bearing (13) and the
spacer (10) and subsequently, to determine the preload for
the bearings.
FIGURE 32: Position the internal bearing (9) and the pinion (8)
under a press; force the bearing onto the pinion.
74
Dana Holding Corporation
H
H
T7C
T26C
T7B
T26B
FIGURE 33: Fit the pinion (8), shim "S1" (11) and spacer (10)
in the main body (12).
The thinner shims must be placed in-between the thicker
ones.
11 S1
FIGURE 34: Insert the external bearing (13) in the central
body in order to complete the pack arranged as in the figure.
8
9
FIGURE 35: Connect the pinion (8) to the tie rod T8A (See
drawing T8 p. 82) and T8B (See drawing T8 p. 82); connect
the tie rod T8C (See drawing T8 p. 82) (see special tools) to
the press and block.
12
8
NOTE:
9
11
8
ASM-0025E - 212 Axle Service Manual
10
11
10
13
Advertisement
Table of Contents
