Agilent Technologies G8610A Operation Manual page 18

Agilent Technologies Helium Leak Detector
WARNING
CAUTION
Touch Panel Display
CAUTION
Radio
Equipment tightness is guaranteed for normal operating
conditions when the equipment leaves the factory. It is the
user's responsibility to maintain the level of tightness,
particularly when pumping dangerous products.
The performance and operating safety of this equipment can
only be guaranteed if it is operated according to normal
conditions of use.
Allow at least 2 to 3 feet of clearance adjacent to the slots at the
front, sides and back of the equipment enclosure.
Allow sufficient room for the operator to safely maneuver to
perform testing.
Do not apply excessive pressure to the Touch Panel display as this
may cause smears.
In general, the lower the temperature, the longer it takes the Touch
Panel display to turn on. Performance of the Touch Panel display
may deteriorate in low temperature.
The Wireless Remote Control and Base Board PCB are built around
Laird's, model RM024, RF transceiver module operating in 2.4
GHz ISM band. The same type of the RF module is built in an Agi-
lent Technologies Helium Mass Spectrometer Leak Detector Wire-
less Base Station PCB and Wireless Remote unit (see Agilent
Technologies Helium Mass Spectrometer Leak Detector Wireless
Remote Operational Manual (6999099945A)).
Agency Identification Numbers for Laird, Model: RM024
AC4424-100:
❑
US/FCC ID: KQL-RM024
❑
CAN/IC: RSS-210
❑
EUR/ETSI EN: CE
❑
Taiwan: CCAI13LP3400T1, CCAI13LP3330T3
are also applied to the Agilent's Wireless Remote and Agilent Tech-
nologies Helium Mass Spectrometer Leak Detector Wireless Base
Station, when the units are used the approved antennas.
18