Agilent Technologies G8610A Operation Manual page 19

Power and Static Sensitivity
19
Agilent Technologies Helium Leak Detector
The Wireless Remote complies with Part 15 of the FCC Rules.
WARNING
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that
may cause undesired operation.
To satisfy RF exposure requirements for mobile type transmitting
devices, maintain a separation distance of 20 cm or more between
the antenna of the Wireless Remote and persons during operation.
Maintain a separation distance of 20 cm or more between the oper-
ator and the RF antenna of the leak detector with a wireless base
station.
Use only approved type of antennas for:
CAUTION
❑
Wireless Remote: Centurion, Model WCP2400-MMCX2,
www.centurion.com.
❑
Agilent Technologies Helium Mass Spectrometer Leak
Detector Wireless Base Station, Nearson, Model
S181FL-5-RMM- 2450S, www.nearson.com
Depending on the unit configuration ordered, the mains power
WARNING
supply requirements for Agilent Technologies Helium Mass
Spectrometer leak detectors are:
❑
100 VAC, 50 Hz, 5 A
❑
115 VAC, 60 Hz, 5 A to 9 A (G8611A) or
❑
230 VAC, 50/60 Hz, 3 A to 4 A
Before powering the unit for the first time, verify that the unit is
configured to operate for the local mains supply voltage. Need
nominal current for all models.