Agilent Technologies G8610A Operation Manual page 20

Agilent Technologies Helium Leak Detector
Use surge protection to improve the immunity of the leak
CAUTION
detector against unidirectional transients caused by the
following phenomena:
❑
Switching phenomena in the power network
(e.g., switching of capacitor banks, inductive loads,
electrical motors, etc.)
❑
Faults in the power network
❑
Indirect lightning strokes
Many components of the leak detector are static sensitive.
CAUTION
Wear a grounding device when performing any maintenance
on the leak detector, especially when performing maintenance
of static sensitive parts, such as circuit boards and the
spectrometer.
This equipment has been tested and found to comply with the
CAUTION
limits for Class A digital device, pursuant to Part 15 of FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference when it is operated in a
commercial environment.
This equipment generates, uses, and can radiate RF energy,
which if not installed and used in accordance with the
instructional manual, can cause harmful interference to
radio communications.
When this equipment is operated in a commercial
environment, operation is subject to the following two
conditions:
❑
This equipment must not cause harmful interference.
❑
This equipment must accept any interference received,
including interference (RF and ESD) that may cause
undesired operation.
The equipment may need to be reset after RF and/or ESD events
by cycling the Power Switch/Circuit Breaker on the back panel
of the unit.
Operation of this equipment in a residential area is also likely to
cause harmful radio communications interference, in which
case, the users will be required to correct the interference at
their expense.

20