Installing The Switch On A Concrete Wall - Allied Telesis AT-IE300-12GP Installation Manual

Installing the Switch on a Concrete Wall

This section contains instructions on how to install the switch on a
concrete wall.
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.
Here are the tools and material required for installing the switch on a
concrete wall:
Two wall brackets (included with the switch)

Four bracket screws (included with the switch)

Four wall screws (not provided)

Cross-head screwdriver (not provided)

Drill and 1/4" carbide drill bit (not provided)

Four anchors and screws for attaching the switch to the wall (not

provided). The diameter of the screw holes in the wall brackets is
4.5 mm (0.17 in.).
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch in a table.
2. Install the two brackets that come with the switch to the back panel of
the unit. Refer to Figure 21 on page 69.
3. Have a person hold the switch on the concrete wall at the selected
location for the device while you use a pencil or pen to mark the wall
with the locations of the four screw holes in the two wall brackets.
Refer to Figure 23 on page 72.
Please follow these guidelines as you position the switch on the wall:
The switch must be oriented as shown in Figure 23 on page 72.

You may not install the switch horizontally or upside-down.
Be sure to leave sufficient space from other devices or walls to

allow for adequate air circulation around and through the cooling
IE300 Series Installation Guide
71